How To Decorate A Parrot Cage

The best cage size for parrots is about 40 x 40 x 60 cm, and the best shape is rectangular. They will not allow birds to injure their heads due to a lack of orientation within the wire circle.

If you often take out your parrot, then you do not need to buy a large cage. When you visit friends or just travel with a bird, the cage should fit freely in the car. It is optimal to have both a small cage for traveling and a large one. The parrot can easily move along the thread if it is fixed horizontally.

Mount and Suction Cups

In general, the parrot cage is equipped with too large wall mounts without observing the diameters for the legs of the bird. Try to grind the top layer so that their diameter matches the diameter of the paw of a bird or use special suction cups with horizontal and vertical mounts. Place two mounts or suction cups in parallel lines, not across them, to avoid falling onto the bottom mount.

The upper suction cup should allow the bird to be upright at least 1 cm from the roof, and its tail feathers should not touch the wire with forward bending. Birds also love to sit on the upper mount when they sleep, because they feel more secure. Even if the space under the roof for parrots is not enough, the bird will sit, but in a curved position.

Too large a space, on the other hand, means that the inside of the parrot cage is not being used properly. Birds use the lower handrail to get to food, which is usually located below the door. Nearby there is another handrail that extends beyond one side. It is at the highest point. A parrot needs space for its tail feathers. When he sits at the end of this handrail, his litter will not fall into the dishes or onto the lower suction cups.

Read more:  Learning To Make A Quail Cage Yourself

Feeder and door

Fasten the parrot feeder to prevent squeezing through the hole. You must not allow the bird to push it from the inside. Use a clamping device to close the outlet openings. If you want to equip the parrot’s home with automatic food dispensers, fasten them with a clamp over the handrails and the feeder.

The fastening procedure can be demonstrated by purchasing a dispenser for parrot cells. Install the holes for the dishes not lower than the door opening. According to R. Low, food distributors are not designed for true bird lovers who care for parrots and feed them daily.

In addition, food can be blocked in the neck and they cannot get to food. It is possible that an unappetizing layer of dust forms at the bottom of the plate. In addition, contents can spill across the floor when birds hang on the outside of the cage. In general, typical commercial dispensers can be easily repelled by birds, so it is not recommended to use them in parrot cages.

It is desirable that the cages of the door are open from top to bottom, this will reduce the risk of injury to the bird. If the door has hinges on the side, be careful as the protruding ends of the wire will be bent. Try to bend them in the opposite direction with the help of pliers.

Fasten those doors that swing down from the top or are pulled up so that they do not open.

The front of the cage should have a hinged door and additionally with a small door. Thus, the bird can fly directly to the handrails. It also helps when you have a naughty bird that needs to be lured back into the cage somehow. To do this, use a large and wide door.

Read more:  How To Make Wooden Cages For Songbirds

To broaden your horizons or write a quality report and essay, we strongly recommend that you read the articles below. We are convinced that after reading these articles, you will learn a lot of unique and useful information. We wish you a good mood in our friendly team!

How to decorate a parrot cage

Pin It on Pinterest

Share This